Calco Dimsport MyGenius Instructions

Setup, connect, and Update your Calco Tuning My Genius Programmer

  • Install the Dimsport MyGenius Client V2 from the USB Drive (Included in the package from the Device)
  • Connect the MyGenius to the PC via USB
  • Start the MyGenius Client V2 program and click UPDATE

Searching for the correct Protocol (Automatic)

  • After finishing the update, disconnect the USB and READ the Unit via Diagnostic Port
  • The Tool will be setup for whichever brand you ordered and should be ready to read the vehicle ECM.

Reading the ECU/ECM (Engine Control Unit/Module)

You can proceed with “READ” on the MyGenius Programmer.
On some brands you get the full readout from the ECU with “READ”. Continue on the MyGenius Programmer. 

  • Select "READ"
  • The MyGenius will Prompt you to connect the vehicle to a battery stabilizer, then click OK. Use your best judgment. 
  • Allow the Mygenius to complete the read process and your follow all of the prompts

If the readout “READ” was ok it will be shown on the display and saved on the device, disconnect the MyGenius Programmer from the vehicle and connect it back to the Dimsport MyGenius Client V2 Program VIA USB to the PC.

John Deere Phoenix ECU Codify/Injector Data/EEPROM:

You absolutely MUST Save the Codify or Injector data from every John Deere you read and plan on writing. Should you have an issue and need to replace the ECU, you will not need to remove the valve cover and reinstall the injector data.

  • Under the Main Menu Select "WORK"
  • If you are reading an L21 Phoenix ECU you will have an option to Read and Save the EEPROM and The CODIFY. 
    • Select "TOOL" 
    • Start by Reading and Saveing the CODIFY
    • Then Read and Save the EEPROM. 
    • Send the ECU Read, EEPROM and CODIFY to Calcotuningmx@proton.me
  • If you are Reading an L33 Phoenix ECU You will have the option to Read and Save the CODIFY
    • Select "TOOL" 
    • Start by Reading and Saving the CODIFY
    • Send the ECU Read and CODIFY to Calcotuningmx@proton.me

Download the software from the MyGenius Programmer, save it on the PC and send it with all important information (Brand, Type, Model, Engine, HP, Year, and request) to calcotuningmx@proton.me

Programming the Tune File:

  • Within 1 business day the tuning file will be finished and you will receive it back via E-Mail.
  • Upload the mod file to Dimsport MyGenius and write it to the vehicle. If 2 mod files are requested you can select between them on the device.

  • Plugin the device
  • Select "Work" Under the MAIN MENU
  • Then Select WRITE
  • Select the Desired File, the information regarding the tune will be in the INFO Section.
  • The MyGenius will Prompt you to connect to a battery stabilizer. Use you best Judgment.
  • You will be prompted to Switch the Dashboard on. Switch it on and select OK to continue. 
  • Follow all of the prompts until the Device indicates the ECU Writing is complete.
  • Do not disconnect the MyGenius Programmer until the log is complete. 
  • Now the tuning file was successfully written into the ECU.
  • Disconnect the MyGenius Programmer from the vehicle and do a test drive.
Back to blog